Chapter 2 FactoryTalk Batch Server introduction
30
11. Select Add. The Select User and Computer dialog box opens.
12. In the Filter Users box, select Show All.
13. In Users, select OPER.
14. Select OK. The Configure Securable Action dialog box is updated,
showing OPER in the list of Users with the Allow checkbox selected.
15. Select OK to close the Configure Securable Action dialog box.
16. Select OK to close the Access Modes Properties dialog box.
See the FactoryTalk Batch Administrator Guide for more information on security.
To set up the sample demonstrations, configure the FactoryTalk Batch Server
to locate the folders that contain the demonstration files and to the \Restart
and bin folders where the FactoryTalk Batch Server writes data upon system
failure. Configure the FactoryTalk Batch Server in the FactoryTalk Batch
Equipment Editor.
To configure the sample FactoryTalk Batch Server:
1. Select Start > Rockwell Software > Equipment Editor. The FactoryTalk
Batch Equipment Editor opens (log on to FactoryTalk if prompted).
Administrator privileges are required to perform this procedure.
2. Select Options > Server Options. The Server Options dialog box opens
to the Project Settings tab.
3. In the Project Directories area, select the Primary Journal browse
button. The Select Directory dialog box opens.
4. From the Look in list, select the SampleDemo1\Journals folder, and
then select Open.
5. Select the Error Logging browse button. The Select Directory dialog
box opens.
FactoryTalk Batch Server
To Next Page
Loading...
Need help?
General
