Chapter 5 FactoryTalk Batch View introduction
77
TEST_2 batch. You must adjust the column headings to view the entire
message as shown in this figure.
When you are testing your recipe, you may want to test only one phase at a
time. In this exercise you acquire control of a specific phase and run it
manually.
Tip: If the Filtering area does not display, select the left split bar and drag to the right.
To control a phase manually:
1. Select the Phase Control button. The Phase Control view opens and
displays the process cell.
2. Double-click the WEST_PARLOR icon to view the units within the
WEST_PARLOR process cell.
3. Select the WP_MIXER1 icon. A list of the phases in WP_MIXER1
displays in the Phases section. You may need to move the vertical split
bars to the right or left so your window appears as shown.
To Next Page
Loading...
Need help?
General
