Chapter 3 FactoryTalk Batch Equipment Editor introduction
45
6. Select the Signoffs tab.
7. In the Template Name field, make sure CommandsTemplate is
selected.
8. From the Signoff dropdown, select 1 (this represents the Signoff you
are going to configure.)
9. In the Meaning field, type Authorizes commands.
10. From the Comment drop-down, select Optional.
11. In the Security Permissions area, select the Add button. The Select
User or Group dialog box opens.
12. In the Filter box, select Show all.
13. Select OPER and select OK. (See the FactoryTalk Batch Administrator
Guide for more information on security.)
14. Select OK to save the Create Signature Template dialog box. (See the
FactoryTalk Batch Equipment Editor User Guide for more information on
creating and configuring Signature Templates.)
Signature templates can be used to request signoffs for reports and
parameters, and can be configured to request a signoff when specified
commands are generated from within the FactoryTalk Batch View.
The template you created in the previous section, CommandsTemplate, will be
used to generate a signature request when the START command is issued
from the FactoryTalk Batch View application. This requires that you enable
Command Verification Policies.
Use signature templates