Rockwell Automation PanelView Plus 1000 User Manual

Publication 2711P-UM001I-EN-P - December 2008 147
Install and Replace Components Chapter 6
Install or Replace a
Communication Module
This section shows how to install and replace a communication
module. The communication module installs over the logic module.
The communication modules are available as separate catalog
numbers for specific communication protocols.
PanelView Plus 700 to 1500 Terminals
Follow these steps to install a communication module.
1. Disconnect power from the terminal.
2. Set the terminal, display side down, on a clean, flat, stable
surface to prevent scratches if the terminal is removed from
panel.
3. Remove the label covering the communication module
connector on the logic module.
4. Position the communication module over the logic module so
that the connectors on bottom of module align with connectors
on the logic module.
TIP
The logic module must be attached to the display module
before you attach the communication module.
Logic Module
REMOVE LABEL TO INSTALL
COMMUNICATION MODULE

Rockwell Automation PanelView Plus 1000 Specifications

General

Brand	Rockwell Automation
Model	PanelView Plus 1000
Category	Touch terminals
Language	English