228 Publication 2711P-UM001I-EN-P - December 2008
Chapter 10 Maintenance
Disposal Information
This section contains disposal information for the backlight assembly
and battery.
Backlight Assembly Disposal
Battery Removal
Follow these steps to remove the battery on the 400 and 600
terminals.
1. Disconnect power from the terminal.
2. Place the terminal, display side down, on a flat stable surface.
3. Detach the communication module, if attached, from the logic
module by removing the three screws.
4. Unlatch the eight retaining tabs (two on each side) on the back
cover and remove cover.
5. Locate the yellow battery on the logic board.
6. Remove the battery.
For information on battery replacement or removal for 700 to 1500
terminals, see Replace the Battery
on page 153.
ATTENTION
The backlight assembly of 600 to 1500 terminals contains
mercury. At the end of its life, this equipment should be
collected separately from any unsorted municipal waste.
At the end of its life, the battery contained in this product
should be collected separately from any unsorted municipal
waste.
Retaining tabs
Battery
To Next Page
Loading...
Need help?
General
