31Publication 2711P-UM001I-EN-P - December 2008 31
Chapter
2
Installation
Chapter Objectives
This chapter provides pre-installation information and procedures on
how to install the terminals.
• Hazardous locations
• Environment and enclosure
• Outdoor installation for 1250 high-bright display module
• Required tools
• Clearances
• Panel cutout dimensions
• Mount the 400 or 600 terminal in a panel
• Mount the 700 to 1500 terminals in a panel
• Product dimensions
Hazardous Locations
This equipment is suitable for these locations:
• Class I, Division 2, Groups A, B, C, D.
• Class I, Zone 2, Group IIC.
• Class II, Division 2, Groups F, G.
• Class III.
• ordinary, nonhazardous locations.
The following statement applies to use in hazardous locations.
WARNING
Explosion Hazard
Substitution of components may impair suitability for hazardous
locations.
Do not disconnect equipment unless power has been switched
off and area is known to be nonhazardous.
Do not connect or disconnect components unless power has
been switched off.
All wiring must comply with N.E.C. articles 501, 502, 503,
and/or C.E.C. section 18-1J2 as appropriate.
Peripheral equipment must be suitable for the location in which
it is used.
To Next Page
Loading...
Need help?
General
