12
3 Preparing the CX-24/12
3 Preparing the CX-24/12
Make sure the unit is placed on a stable, sturdy surface.
Installing requires the space shown below.
Never install this unit in any of the following situations, as it could result in damage:
• Places where the installation surface is unstable or not level.
• Places with excessive electrical noise.
• Places with excessive humidity or dust.
• Places with poor ventilation, because the CX-24/12 generates considerable heat during operation.
• Places with excessive vibration.
The material moves during cutting. Do not place
obstacles that may obstruct the material at the front and
rear of the machine.
3-1 Setting
NOTICE
CX-24: 950 mm (37-7/16 in.)
CX-12: 650 mm (25-5/8 in.)
500 mm
(19-11/16 in.)
Ground the unit with the ground
wire.
Failure to do so may result in risk of
electrical shock in the even of a mechanical
problem
Do not use with any electrical power
supply that does not meet the
ratings displayed on the unit.
Use with any other power supply may lead
to fire or electrocution.
Install on a stable surface.
Failure to do so
may result in
falling of the unit,
leading to injury.
When moving the machine, do not attempt to lift or carry it by grasping the top portion of the machine. Lift and
carry the machine by holding it with your hands along the left and right sides of the machine.
CX-24
950 mm (37-7/16 in.) wide, 500 mm (19-11/16 in.) in
depth, and 300 mm (11-13/16 in.) in height.
CX-12
650 mm (25-5/8 in.) wide, 500 mm (19-11/16 in.) in
depth, and 300 mm (11-13/16 in.) in height.
300 mm
(11-13/16 in.)
To Next Page
Need help?
General