Roland Camm-1 CX-24/12 User Manual

56
Index
Index
A
Acceptable material widths ................................................... 39
Affix the material .................................................................. 31
Amount of blade extension............................................. 27, 51
AREA .................................................................................... 43
AUTO .................................................................................... 45
B
#BAUD. ................................................................................. 46
Bit rate ................................................................................... 16
Blade and material combinations .......................................... 38
Blade holder .......................................................................... 51
Blade life ............................................................................... 38
Blade protector ........................................................ 10, 20, 51
Buffer..................................................................................... 36
C
CALL..................................................................................... 45
CAMM-1 Driver............................................................. 15, 28
CLEAR ........................................................................... 36, 44
Communication parameter .................................................... 15
Control panel ......................................................................... 22
Crossover serial cable ............................................................ 13
Cutting area .................................................................... 28, 40
Cutting carriage ..................................................................... 10
Cutting test ............................................................................ 26
D
Data bit .................................................................................. 16
#DATA. .................................................................................. 46
Dial ........................................................................................ 11
Display................................................................................... 11
Display menu descriptions .................................................... 42
Display menu flowchart ........................................................ 48
Driver selection ..................................................................... 50
E
EDGE ...................................................................... 21, 25, 42
Error messages ...................................................................... 52
EVEN .................................................................................... 46
F
Flat material ............................................................. 21, 28, 40
Flow control .......................................................................... 16
FORCE .................................................................................. 43
G
Grit roller ...............................................................................10
Guide line marks ............................................................ 10, 20
H
#HANDS. .............................................................................. 46
Hardware handshaking .......................................................... 16
Hardwire handshaking ........................................................... 46
HEAVY........................................................................... 45, 51
How to view the display ........................................................ 22
I
I/O.......................................................................................... 45
Installing ................................................................................ 15
Installing blade ...................................................................... 17
Instruction support chart........................................................ 53
K
Knife guide ..................................................................... 10, 32
L
LIGHT ................................................................................... 45
Loading the material.............................................................. 18
Location of the origin point ................................................... 25
M
Material feed.......................................................................... 23
Material widths ...................................................................... 18
[MENU/PARAM] key .................................................... 11, 22
N
NONE .................................................................................... 46
O
ODD ...................................................................................... 46
OFFSET................................................................................. 43
Operation panel ..................................................................... 11
[ORIGIN] key................................................................. 11, 25
Origin point ........................................................................... 25
P
Paper media ........................................................................... 35
PARA..................................................................................... 45
Parallel cable ......................................................................... 13
Parallel (Centronics) Input Connector ................................... 10
#PARITY ............................................................................... 46
Parity checking ...................................................................... 16
Pausing cutting operation ............................................... 29, 49
Pen ......................................................................................... 35
Performing long cutting......................................................... 24
PIECE ............................................................... 21, 23, 25, 42
Piece material ........................................................................ 19
Pinch Roller ...........................................................................10
Pinch roller ............................................................................ 50
Plotting .................................................................................. 35
Port setting............................................................................. 15
Position key ........................................................................... 11
Positioning the grit rollers ..................................................... 19
R
Recutting ............................................................................... 37
Removing the material .......................................................... 31
REPLOT ......................................................................... 36, 44

Roland Camm-1 CX-24/12 Specifications

General

Brand	Roland
Model	Camm-1 CX-24/12
Category	Plotter
Language	English