37
7 Repeating the Same Cutting
1
2
1
2
3
1
2
Getting Ready for Recutting
Repeating cutting on different material
Repeating cutting without replacing the material
Turn the dial to display the screen shown at right.
Press the [MENU/PARAM] key.
Turn the dial to display the screen shown at right.
Press the [ENTER] key.
The setup state is released.
Load the new material. For information on how to
load the material, see "4-2 Loading the Material."
Performing Recutting
Turn the dial to display the screen shown at right.
Press the [MENU/PARAM] key.
Press the [ENTER] key.
Recutting starts.
Use the position keys to move the blade holder to the
location for setting a new origin point.
Press the [ORIGIN] key to set the origin point.
SETUP | ON->OFF
SETUP | <ON>
REPLOT| START
REPLOT| START
To Next Page
Loading...
Need help?
General