Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
OIL CHANGE
Instruction
NOTE
Run engine to warm oil before beginning oil change procedure. To change the oil
the following steps are necessary:
Step
Procedure
1
Crank engine slowly by hand to transfer the oil from the crankcase.
See Chapter 12-20-00 section Purging the oil system.
2 Remove safety wire and oil drain screw from the oil tank, drain the used oil -
see environment note.
3
Replace oil filter at each oil change and inspect the filter insert.
See Chapter 12-20-00 section Oil filter replacement and Inspection of the
filter insert.
4
Dispose of oil filter according to environmental regulations.
5
Install oil drain screw with new gasket and safety wire.
ATTENTION
Only use brand name oil in accordance with the latest Operators Manual and the
latest Service Instruction “Selection of suitable operating fluids“ of the respec-
tive engine type.
ATTENTION
The engine must not be cranked when the oil system is open. Attention must also
be paid to this before first commissioning (e.g. when assembling the propeller
after correct purging of the oil system).
ATTENTION
Compressed air must not be used to blow through the oil system (or oil lines, oil
cooler, oil pump housing, oil bores in the engine).
ENVIRONMENTAL NOTE
Protect the environment.
Do not harm the environment by spilling oil. Dispose of oil in an environmentally friendly
manner.
12–20–00
Page 34
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0

Rotax 912 i series Specifications

General

Brand	Rotax
Model	912 i series
Category	Engine
Language	English