Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
DIMINISHED FUNCTIONAL CAPABILITY OF EMS
General note
NOTE
The diminished functional capability of EMS must be entered by the pilot into the
engine log book, stating duration extent of diminished functional capability and all
pertinent details.
• Perform engine inspection.
Read out the ECU data memory and check the data for details of diminished functional ca-
pability. Perform the corresponding inspections/repairs depending on the functional de-
fects found.
RETURNING ENGINE TO SERVICE AFTER INFLUENCE BY FIRE
General note An engine after influence by fire must be inspected, repaired or overhauled in accordance
with the BRP-Rotax instructions for continued airworthiness.
Inspection • Inspect all systems for correct functioning.
NOTE
Prior to the detailed inspection, all parts should be cleaned and inspected for burn
penetration or melted materials.
If an engine was influenced by fire, first a visual inspection of all parts has to be done and
then a hardness test of all mechanical parts must be performed
(e. g.: crankcase, cylinder, cylinder heads etc.).
In most cases an overhaul is necessary, in this regard send the engine without delay to an
authorized ROTAX® overhaul facility for inspection.
EXCEEDING OF MAX. ADMISSIBLE ENGINE RPM
General note
ATTENTION
Any exceeding of the max. admissible engine RPM must be entered by the pilot
into the engine log book stating duration extent of overspeeding and pertinent
detail.
Read out the ECU data memory and check the data for details of increased engine speed.
Perform the corresponding inspections/repairs depending on the functional defects found.
5800 rpm up to
max. 6200 rpm
If the limit was exceeded for max. 1 minute up to 6200 rpm
Step
Procedure
1 No action is required.
05–50–00
Page 18
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0

Rotax 912 i series Specifications

General

Brand	Rotax
Model	912 i series
Category	Engine
Language	English