Manual Wireless Network Setup
If the network requires a static IP address, enter the IP address, subnet mask, gateway and DNS values
to connect to the network manually. To get the IP address, subnet mask, gateway and DNS values,
contact your Internet Service Provider (ISP). Refer to the "Dynamic versus Static IP Addresses" for
more information.
1.
Setting Network Type to Wireless automatically displays a list of available wireless networks.
Network Settings
Select your network type.
Network Type Wireless
Wireless network
AP0000
AP0001
Add Network
You can connect your TV to the
internet. Please select which
wireless network to use.
Refresh WPS(PBC)
2.
Select the network (SSID) you wish to connect to. If the desired wireless router doesn't appear in
the list, select Add Network and enter the network's SSID manually.
3.
Enter the security key and select Done. If the selected network is not security-enabled, the TV will
attempt a connection right away.
4.
Select Stop when the TV attempts to connect to the network. Once the network connection has
been interrupted, select IP Settings.
Network Settings
Connection verification cancelled.
Wireless network connection test stopped.
Change Network IP Settings Retry Close
To Next Page
Loading...
Need help?
General
