Using the WPS Button
If the router has a WPS push button, you can use it to connect the TV to the router automatically. WPS
automatically configures the SSID and WPA key settings.
1.
Setting Network Type to Wireless automatically displays a list of available wireless networks.
2.
Select WPS(PBC) and then press the router's WPS button within two minutes.
3.
The TV automatically acquires the SSID and security key settings and connects to the network. A
confirmation message is then shown once a connection is established. Select OK to proceed.
Failed Wireless Connection
Wireless network connection failed, or no wireless router selected.
Try Now
Try Now
Go to Network Settings and select the correct router.
Unable to connect to a wireless router
Try Now
Try Now
Check the following:
1.
Check that the router is turned on, and if it is, turn it off and on again.
2.
Enter the correct security key if required.
IP auto setting failed
Try Now
Perform the following or set the IP address manually from IP Settings.
1.
Make sure that the DHCP server is enabled on the router and unplug and plug the router back in.
2.
Enter the correct security key if required.
3.
If this does not work, contact your Internet Service Provider for more information.
To Next Page
Loading...
Need help?
General
