Sanyo PLC-SW30 User Manual

23
Computer Input
Computer System Selection
This projector automatically tunes to various types of computers based on VGA, SVGA, XGA or SXGA with its Multi-scan
system and Auto PC Adjustment. If Computer is selected as a signal source, this projector automatically detects the signal
format and tunes to project a proper image without any additional setting. (Signal formats provided in this projector is
shown on page 49 )
When projector cannot recognize connected signal as PC
system provided in this projector, Auto PC Adjustment
function operates to adjust projector and the message
“Auto” is displayed on System Menu icon. (
☞ P24.)
When image is not provided properly, manual adjustment
is required. (
☞ P25 - 26 )
There is no signal input from computer. Make sure the
connection of computer and a projector is set correctly.
(
☞ " Troubleshooting" P44 )
Auto
-----
System Menu icon
Displays system being
selected.
PC SYSTEM MENU
Selecting Computer System Manually
SYSTEM Menu icon
Displays system being selected.
The systems on this dialog box
can be selected.
Press MENU button to display the On-Screen Menu. Press Point
7 8 buttons to move the red frame pointer to PC SYSTEM
Menu icon.
Press Point d button to move the red arrow pointer to the
system that you want to set, and then press
SELECT button.
1
2
PC SYSTEM MENU
Custom Mode (1–5) set in PC
Adjust Menu. ( ☞ P24-26 )
PC system can be also selected manually.
Note : The projector may display one of the following messages.
User preset adjustment in Computer Adjustment.
Adjustment data can be stored in Mode 1 - 5. (
☞ P25-
26 )
Mode 1
Computer systems provided in the projector. The
projector chooses a proper system and displays it.
SVGA 1
*Mode 1 and SVGA 1 are examples.

Sanyo PLC-SW30 Specifications

General

Native aspect ratio	4:3
Projection distance	- m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	3LCD
Contrast ratio (typical)	300:1
Screen size compatibility	34 - 200 \
Projector native resolution	SVGA (800x600)
Keystone correction, horizontal	20 °
Lamp type	UHP
Lamp power	150 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	2500 h
RMS rated power	0.8 W
Number of built-in speakers	1
Power source	AC
AC input voltage	100 - 240 V
Power consumption (standby)	- W
Power consumption (typical)	244 W
Power consumption (PowerSave)	169 W
Focus	Manual
Throw ratio	1.6 - 1.9:1
Focal length range	- mm
Aperture range (F-F)	1.6 - 1.8
HDCP	-
Noise level	- dB
Dot clock scanning frequency	100 MHz
Full HD	No
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions	800 x 600 (SVGA)
USB connector type	USB Type-B
HDMI ports quantity	0
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Placement	Desktop
Product type	Standard throw projector
Product color	Black, White
Cables included	AC, VGA
Remote control type	IR

Weight and Dimensions

Depth	190 mm
Width	270 mm
Height	78 mm
Weight	2100 g