Sanyo PLC-SW30 User Manual

43
Maintenance
Cleaning the Projection Lens
Apply a non-abrasive camera lens cleaner to a soft, dry cleaning
cloth. Avoid using an excessive amount of cleaner. Abrasive
cleaners, solvents or other harsh chemicals might scratch a
surface.
When the projector is not in use, replace the Lens Cover.
1
3
Lightly wipe Projection Lens with a cleaning cloth.
2
Follow these steps to clean the projection lens:
Air Filter
Turn off the projector, and disconnect AC power cord from the
AC outlet.
Turn the projector upside down and remove air filters by pulling
the latches upward.
1
2
Removable air filters prevent dust from accumulating on the surface of optical elements inside the projector. Should air
filters become clogged with dust particles, it will reduce the cooling fans’ effectiveness and may result in internal heat build
up and adversely affect the life of the projector. Clean air filters following the steps below:
Clean the air filters with a brush or wash out dust and particles.
3
Replace each air filter properly. Make sure that the air filters are
fully inserted.
4
CAUTION
Do not operate the projector with the air filters removed.
Dust may accumulate on optical elements inside the
projector degrading picture quality.
Do not put small parts into Air Intake Vents. It may result in
malfunction of the projector.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when
operating a projector. Usage in these environments may cause
poor image quality.
When using under dusty or smoky conditions, dust may accumulate
on or optical elements inside the projector. This condition may
degrade the quality of a projected image.
When the above symptoms are noticed, contact your authorized
dealer or service station for proper cleaning.
Air filters

Sanyo PLC-SW30 Specifications

General

Native aspect ratio	4:3
Projection distance	- m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	3LCD
Contrast ratio (typical)	300:1
Screen size compatibility	34 - 200 \
Projector native resolution	SVGA (800x600)
Keystone correction, horizontal	20 °
Lamp type	UHP
Lamp power	150 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	2500 h
RMS rated power	0.8 W
Number of built-in speakers	1
Power source	AC
AC input voltage	100 - 240 V
Power consumption (standby)	- W
Power consumption (typical)	244 W
Power consumption (PowerSave)	169 W
Focus	Manual
Throw ratio	1.6 - 1.9:1
Focal length range	- mm
Aperture range (F-F)	1.6 - 1.8
HDCP	-
Noise level	- dB
Dot clock scanning frequency	100 MHz
Full HD	No
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions	800 x 600 (SVGA)
USB connector type	USB Type-B
HDMI ports quantity	0
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Placement	Desktop
Product type	Standard throw projector
Product color	Black, White
Cables included	AC, VGA
Remote control type	IR

Weight and Dimensions

Depth	190 mm
Width	270 mm
Height	78 mm
Weight	2100 g