26 Section 2A: Your Phone – The Basics
Making and Answering Calls
Making Calls
Placing a call from your wireless phone is as easy as making a
call from any landline phone. Just enter the number and press
, and you’re on your way to clear calls.
To make a call using your keypad:
1. Make sure your phone is on.
2. Enter a phone number from standby mode. (If you make
a mistake while dialing, press to erase one digit at
a time. Press and hold to erase the entire number.)
3. Press or . (To make a call when you are
roaming and Call Guard is enabled, see “Using Call
Guard”on page 87.)
4. Press or close the phone when you are finished.
Tip: To redial your last outgoing call, press or twice.
Tip: When making calls off the Nationwide Sprint PCS Network, always dial
using 11 digits (1 + area code + phone number).
You can also place calls from your phone by using Sprint PCS
Voice Command (page 228), by speed dialing numbers from
your Contacts (page 39), by using your Call History listings
(page 92), and by using Voice-Activated Dialing (page 122).
Important: To maximize performance
when using your phone, extend the
antenna before a call and do not touch the
antenna during a call.
To Next Page
Loading...
Need help?
General
