USING THE CAMERA WITH A COMPUTER
Using the camera as your computer’s
external drive
1
Turn off your digital camera (see page 30).
2
Using the supplied dedicated USB interface cable, connect the
camera connector to the camera and the computer connector to the
proper terminal on your computer.
œ Please connect the dedicated USB interface cable to your computer’s
USB connector. Do not connect it to the USB port on your monitor or
keyboard, or to the USB hub. Be especially careful when installing the
driver software. In some instances, it may not be possible to correctly
install the driver software.
3
Set the main switch to [PC], and turn
on the power.
œ The camera changes to the PC
connection mode.
œ More information about these
operations can be found in the
instruction manual accompanying the
included Sanyo Software Pack.
NOTE
œ When the digital camera is set to the PC connection mode, no image is
shown on the LCD monitor.
To the DIGITAL/VIDEO terminal
To USB port
Dedicated USB interface cable (supplied)
PC
Main switch
SX714/EX, GX, U (VPC-S1 GB) Thu. July, 17/2003
English
126
To Next Page
Loading...
Need help?
General
