Error messages and malfunctions
Page 6-4 BASO 1 MS - 02.06 - V02
6.2 Error messages with display
6.2.1 Error messages - coffee machine
Inform your authorized customer service representative immediately if you cannot
clear an error message using the tips below!
Do not attempt to repair the espresso machine yourself!
Display Cause Rectification
drain tank full
(sTxt-187)
- This message only applies to coffee ma-
chines without a fixed wastewater outlet
- The floating switch has communicated this.
The coffee machine cannot be operated.
- Empty the wastewater container and then
press
[ ] / STOP.
heating
(sTxt-172)
-When the coffee machine is switched on,
no products can be served until the system
warms up.
- Excessive steam outputs.
- Phase fuse defective.
- Safety switch has opened.
The coffee machine is blocked.
- You can dispense coffee and hot water
products after approx. 5 minutes.
-Check the phase fuse.
- If the message persists, contact a manu-
facturer-authorised customer service rep-
resentative.
heating steam
(sTxt-175)
- Excessive steam outputs.
- Phase fuse defective.
- Safety switch has opened.
Steam outputs are disabled other products
can be dispensed.
- You can dispense coffee and hot water
products after approx. 5 minutes.
- Check the phase fuse.
- If the message persists, contact a manu-
facturer-authorised customer service rep-
resentative.
heating Tea
(sTxt-174)
- Excessive hot water outputs right.
- Phase fuse defective.
- Safety switch has opened.
Hot water outputs are disabled other prod-
ucts can be dispensed.
- You can dispense coffee and hot water
products after approx. 5 minutes.
- Check the phase fuse.
- If the message persists, contact a manu-
facturer-authorised customer service rep-
resentative.
Flowmeter error
(sTxt-176)
- Fresh water supply is blocked or one of the
stop valves is defective.
- Brewing unit is dirty.
Products can still be served.
- Open stop valve.
- Clean the brewing unit.
- If the message persists, contact a manu-
facturer-authorised customer service rep-
resentative.
motor error
(sTxt-190)
- Control defective.
The coffee machine cannot be operated.
- Contact a manufacturer-authorised cus-
tomer service representative.
motor control
(sTxt-180)
- The control unit has recorded an error
function of the motor in the left brewing
unit.
Left coffee outlets are disabled.
- Press the [Standby] - button 2x and select
a espresso product, If the message per-
sists, contact a manufacturer-authorised
customer service representative.
To Next Page
Loading...
Need help?
General
