BASCJ_EN
V03 | 07.2015
13
www.schaerer.comInstallation and commissioning
Installation
Unpacking the machine
► Unpack the machine.
► Check the remaining package contents for accessories.
► Remove the accessories supplied in the grounds container and water tank.
► Keep the original packaging in case the equipment needs to be sent back.
Installing the mains water supply (Option)
Connecting the milk system
► Mounting the milk hose on the beverage outlet (see figure).
► Select a suitable milk nozzle (brown = for cooled milk; transparent = for uncooled milk) and
insert at the lower end of the milk hose.
► Insert the beverage outlet into the holder.
► Remove the grounds container out of the coffee machine.
► Move the beverage outlet to the lowest position.
► Clamp the milk hose into the guide intended for this purpose.
Water inlet temperature
Minimum: 10°C
Maximum: 35°C
Read the "Setting up the coffee machine" and "Power supply" chapters carefully before install-
ing.
Important: When operating the machine with a mains water supply, it is important that you
keep the provided internal drinking water tank. It is needed during the descaling process.
See the supplied installation instructions on the mains water supply.
See "Operation" - "Filling and connecting" - "Milk" for filling milk.
If an external cooling unit is used: install the cooling unit as described in the operating instruc-
tions and route the milk hose from the coffee machine to the external cooling unit.
To Next Page
Loading...
Need help?
General
