BASCJ_EN
V03 | 07.2015
19
www.schaerer.comOperation
Hot water
Three different dosing variants are available for dispensing hot water:
► Place a cup under the hot water outlet.
► Adjust the height of the beverage outlet to the cup size.
Option 1: Portion control
► Press the button.
The set quantity is dispensed.
Option 2: Freeflow
► Press and hold the button.
Dispensing takes place while the button is pressed.
Option 3: Start/stop
► Press the button.
Hot water is dispensed.
► End the dispensing process by pressing the button again.
Hot milk
Hot milk and milk foam are dispensed using the same button.
► Place a cup under the beverage outlet.
► Slide the beverage outlet to the highest position.
Air is always added to the milk unless the outlet is in the highest position.
► Press the button (middle button).
Hot milk is dispensed.
► End the dispensing process by pressing the button again.
Milk foam
Hot milk and milk foam are dispensed using the same button.
► Place a cup under the beverage outlet.
► Adjust the height of the beverage outlet to the cup size.
► Press and hold the button.
Dispensing takes place while the button is pressed.
Double beverages
Two beverages can be dispensed at the same time. This only applies to espresso, café creme
and cappuccino.
► Place two cups under the beverage outlet.
► Adjust the height of the beverage outlet to the cup size.
► Press the required beverage button ca. 3 sec.
Only the symbol of the selected beverage appears; dispensing of the beverage begins.
The display shows "2x beverage name".
► Remove the cups after the beverage has been dispensed.
The service technician can deactivate unrequired dosing variants or adjust the dosing quantity
of the "dosed" variant.
If the dispensing process is not stopped manually by pressing the button, the dispensing
process ends automatically after a defined time period. This can be defined by the service
technician.
If the dispensing process is not stopped manually by pressing the button, the dispensing
process ends automatically after a defined time period. This can be defined by the service
technician.
To Next Page
Loading...
Need help?
General
