78
TRAINING Mode
The training mode is used when the operator or the manager practices register operations.
NOTE
In case “clerk and cashier system” is applied to your register, cashiers can enter to the training
mode.
When a clerk/cashier set in training is selected, the register automatically enters the training mode, while
a clerk/cashier not set in training is selected, the register automatically enters the ordinary REG mode. A
training text and a training clerk/cashier can be programmed.
The training operations are valid in all modes.
A mark which is identifying a training receipt is printed on the receipt which is issued in the training mode.
The consecutive number is not updated. The preceding number is repeated in printing.
Training clerk/cashier programming is performed in PGM2 mode. (It allows for 1 Clerk or 1 Cashier.)
The memory in clerk/cashier is updated in the training mode. Other memories are not updated.
The GLU codes which are opened in the training mode are also printed on the GLU report. In this case,
those GLU codes are distinguished from others by the character of “T”. The data of training GLU codes are
not added to the total.
The reading and resetting of training clerks/cashiers is printed on the clerk/cashier reports. However, the
sales total of training clerks/cashiers is not included in the clerk/cashier total on the full clerk/cashier report.
NOTE
The following operations are effective even in the training mode:
• Changing programs
• Reading and resetting reports
Example
Key operation Print
Selecting the
clerk set in
training
5
U
3
@
3
U
A
To Next Page
Loading...
Need help?
General
Weight and Dimensions
