28
E
Drawing with a Pen
1. Touch one of “Pen 1” to “Pen 3” in the menu.
2. Draw on the board with the touch pen.
The drawn shape will be determined as an object 0.5 second* after you lift the touch pen from the board. If you start drawing
another object within 0.5 second* after you lift the touch pen from the board, the drawn shapes will be determined to be a single
object even though they are separate.
* This period can be changed. (Page 64)
Draw a shape. Draw another shape. Both shapes are determined
as a single object.
Less than
0.5 second
After
0.5 second
TIPS
• You can switch through “Pen 1” to “Pen 3” and “Eraser” by repeatedly pressing function button 2 of a 2 button pen.
To change functions using function button 2, select the Touch Panel Driver “Properties”, and set “Function Button 2” to “Pen
Software Link” on the “Operation Setting” tab.
When using 3 button pen/pointer pen, you can switch through “Pen 1” to “Pen 3” and “Eraser” by repeatedly pressing function
button. To use this function, set “Pen Software Link” to any function button.
When using Touch Pen Utility, assign with “Function buttons” in “Advanced”.
When using Touch pen Management Tool, assign with “Function buttons” in “Touch pen settings”.
• For details about objects, refer to page 37.
• In certain cases, such as when an icon on the menu is touched, the drawn shape will be xed as an object before the
specied time elapses after the touch pen is lifted from the board.
• When “Finger can draw” is set to “Enable”, you can draw with your nger. (Page 57)
To Next Page
Loading...
Need help?
General
