46
E
Using multiple touch pens simultaneously
A maximum of four 3 button pens/pointer pens can be used to draw at once.
To use this function, set “Finger can draw” to “Disable” and “Dual-Touch Gesture” to “Disable”. (Page 57)
When using Touch Pen Utility, set “Input mode” to “Standard”.
When using Touch pen Management Tool, set “Touch Operation Mode Setting” to “Standard Touch Mode”.
n
Drawing with multiple pens
The line color and width of the touch pens can be set separately for “Pen 1” to “Pen 3” and “Eraser”. (Page 29, 30)
The default settings of “Pen 1” to “Pen 3” and “Eraser” can also be set separately. (Page 60)
Caution
• When using the classic menu (page 9) or oating menu (page 10), simultaneous drawing is possible, but the same function,
including settings such as line color and width, will be selected on all pens.
• Multiple boards cannot be used simultaneously, even if displayed in windows.
•
When “Automatically Find Eraser” is set, no pens can be used while a drawn line is erased by an eraser. (Page 58)
• When multiple touch pens are used, touch positions and touch pen information (color, width, etc.) may become interchanged,
and lines may break.
- When touched simultaneously
- When touch pens are moved near each other
- When batteries are low
- When other wireless equipment is operating nearby
• Simultaneous use of multiple touch pens, ngers or erasers may slow down the operation.
TIPS
• Multiple ngers can be used for drawing (excluding the PN-L602B/PN-L702B/PN-L802B).
In that case, set “Finger can draw” to “Enable” and “Dual-Touch Gesture” to “Disable” and then set “Simultaneous Drawing
with Multiple Fingers” to “Enable”. (Page 57, 58)
When using multiple ngers, the function is the same for all ngers.
• Multiple passive pens 2 cannot be used simultaneously.
To Next Page
Loading...
Need help?
General
