225/327
Building Technologies Basic Documentation LMV5... CC1P7550en
14 Duties of the authorized inspector 22.05.2018
14 Duties of the authorized inspector
Prior to approval, the manufacturer must state the assigned DIN registration number
and product ID number, confirming that the LMV5 complies with the type-tested
system.
Also, only the components specified for use with the LMV5 (AZL5, actuating devices,
flame detectors, transformer, and CAN bus cable) may be used and, in addition with
the LMV52, the PLL52 and the QGO20 In the case of VSD operation, we recommend
to use the AGG5.310 accessory set for acquiring the fan speed.
Flame detectors QRA refer to Data Sheet N7712
Flame detectors QRB refer to Data Sheet N7714
Flame detectors QRI refer to Data Sheet N7719
Actuators SQM4 refer to Data Sheet N7814
Actuators SQM9 refer to Data Sheet N7818
Operating and display unit AZL5 refer to User Documentation A7550
Transformer AGG5 refer to Basic Documentation P7550
CAN bus connecting cable AGG5.63 refer to Basic Documentation P7550
Accessory set AGG5.310 for acquiring
the fan speed refer to Basic Documentation P7550
(recommended, if required)
O2 module PLL52 refer to Basic Documentation P7550
O2 sensor QGO20 refer to Data Sheet N7842
Flue gas collector AGO20 refer to Data Sheet N7842
Accessory set AGG5.310 for
acquiring the fan speed refer to Basic Documentation P7550
(recommended)
The mechanical links between the actuators and the fuel and air actuating devices and
any other actuating devices used must be rigid.
In addition, following must be checked:
In addition with
LMV52
To Next Page
Loading...
Need help?
General
