Configuring and Parameterizing the CP 340
5.2 Parameterizing the Communications Protocols
PtP coupling and configuration of CP 340
Manual, 04/2011, A5E00369892-03
95
5.2.2 Installing the engineering tool
Installation
The CP 340: Point-to-Point Communication, Parameter Assignment parameter assignment
interface is located on a data carrier along with the function blocks and programming
example.
To install the parameter assignment user interface:
1. Insert the suppled data carrier in the drive of your programming device / PC.
2. In Microsoft Windows, start the dialog for installing software by double-clicking the "Add
and Remove Programs" icon in the "Control Panel".
3. Select the drive from the dialog window and run the Setup.exe file to start the installation
procedure.
4. Follow the on-screen instructions provided by the setup program.
Further information?
The basic operation of the Point-to-Point Communication, Parameter Assignment user
interface is the same for all communication processors and is self-explanatory. For this
reason, the parameter assignment user interface is not described in detail here.
Also, the online help provides sufficient support for working with the parameter assignment
user interface.
To Next Page
Loading...
Need help?
General
