Siemens Simatic series User Manual

Device maintenance and repair
7.2 Maintenance
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
105
7.2.2 Remove the fan cover
1.
Open the front door until the
marked lock releases the fan
cover, see also section "Opening
the front door (Page 76)".
2.
Take hold of the recessed grip.
3.
Open the fan cover in the
direction of the arrow.
7.2.3 Replacing filters
The filter pad is located behind the fan cover.
Note
You may only use filters of the same type.
Information about the original spare parts for
SIMATIC PCs is available in the Internet at SIMATIC IPC after
-sales information system
(
http://www.siemens.com/asis).
Filter pads are available as a pack of 10 unde
r the article number A5E37019277.
Requirement
● The device is disconnected from the power supply; see section "Switching off the device
(Page 63)".
● The front door is open; see section "Opening the front door (Page 76)".
● The fan cover has been removed; see section "Remove the fan cover (Page 105)".
● A filter pad from the pack of 10 A5E37019277
Procedure
1. Remove the filter pad from the fan cover.
2. Insert the new filter pad into the fan cover. It is inserted loosely in the fan cover. When
you insert the filter pad, make sure it lies evenly in the fan cover.
3. Replace the fan cover.

Siemens Simatic series Specifications

General

Brand	Siemens
Model	Simatic series
Category	Industrial PC
Language	English