34
GB
16.2 Error messages on the display
Display Cause Remedy
E3
The device is overloaded.
Odour / smoke may devel-
op.
• The appliance can be used to pro-
cess up to max. 500g of flour.
• Let the device cool down completely.
Afterwards, it is ready for use again.
Lid34 or deep steamer bas-
ket3 have not been placed
correctly onto the blender
jug5.
Close lid34 correctly (see “Put on the lid
of the blender jug” on page 21).
Or close steamer basket3 correctly (see
“Preparation of the steamer inserts” on
page 24).
The turbo function cannot be
used, since the food temper-
ature inside the blender
jug5 exceeds 60 °C.
Set the speed using the speed control-
ler18 (see “Setting the speed” on
page 17).
HHH
Temperature in the blender
jug5 is too high. There is
not enough food or liquid in
the blender jug5
Switch the device off and let the blender
jug cool down. Then add a sufficient
amount of food or liquid into the blender
jug5.
- - - - The scale is overloaded. Remove some weight from the scale.
__317553_MC_plus_GR_CY.book Seite 34 Freitag, 12. April 2019 10:00 10