7 Transmission Repair
7B Eaton 750 / 751
7 - 16
Axle Disassembly (Eaton 750)
1. Remove and discard the axle housing gasket from
the wear plate.
NOTE: Gasket may have remained on the transaxle
housing during removal of the axle assembly.
2. Remove the wear plate from the axle assembly
Figure B–20. Remove Gasket and Wear Plate
Figure B–21. Remove Gasket and First Sun Gear
3. Remove the axle housing gasket from the ring gear
assembly and discard.
4. Remove the first sun gear from the primary carrier
assembly.
NOTE: The first sun gear may or may not have remained
in the motor rotor during removal of the axle assembly.
Figure B–22. Remove Primary Carrier Assembly
5. Remove the primary carrier assembly from the ring
gear assembly.
Figure B–23. Remove Second Sun Gear
6. Remove the second sun gear from the secondary
carrier assembly.
Figure B–24. Remove Axle Housing Gasket and
Dowel Pins
7. Remove the ring gear assembly from the axle hous-
ing.
8. Remove the gasket and dowel pins from the axle
housing. Discard gasket.
To Next Page
Loading...
Need help?
General
