7 - 49
7 Transmission Repair
7C Tuff Torq K60
2. Remove the three bolts holding the brake cover to
the transmission housing.
3. Remove the snap-ring and brake drum from the
motor shaft.
4. Inspect the brake assembly and brake drum for wear
or damage. Replace if excessive wear of any part is
noted.
NOTE: The brake drum and brake assembly must be
free of oil and dust. If oil is present on brake compo-
nents, the seal on the motor shaft may be suspect.
Replace the seal if oil leakage is evident at the shaft
seal.
NOTE: The brake band and brake cover are serviced as
an assembly.
Figure C–18. Brake Cover Removal
Figure C–19. Brake Drum Removal
Disassembly
1. Remove expansion chamber reservoir from the
transaxle housing. Turn the transaxle upside down
and support on a suitable stand.
Figure C–17. Place Transaxle Upside Down In
Fixture
To Next Page
Loading...
Need help?
General
