7 Transmission Repair
7C Tuff Torq K60
7 - 48
19. Remove the pulley, cam assembly, and support rods.
NOTE: When reinstalling input pulley, new setscrews
must be used. The setscrews have a special soft end
and cannot be reused.
NOTE: Early models do not have a snap ring retaining
the top of the pulley used by later models. For either
model, install a snap ring during reassembly.
Figure C–16. Remove Pulley, Cam Assembly, Rods
18. Remove the cap from the expansion chamber reser-
voir to clear the frame. Slowly lower the jack to
remove the transaxle from the frame. Once
removed, replace the cap.
Figure C–15. Remove Transaxle From Frame
To Next Page
Loading...
Need help?
General
