7 Transmission Repair
7B Eaton 750 / 751
7 - 34
Figure B–89. Install Spacer and Gasket
19. For retention during assembly, apply a small amount
of petroleum jelly (Vaseline) to the spacer. Install the
spacer on the shaft and brake gear. (Not used on
date code G01J or higher.)
20.Install the third and final gasket on the ring gear
assembly.
Figure B–90. Install Axle Shaft and Thrust Washers
Axle Housing Reassembly (Eaton 750)
1. Lubricate and install the axle shaft and thrust wash-
ers in the axle housing.
Figure B–91. Install Thrust Washer & Retaining Ring
2. Position the axle housing assembly with the axle
pointing downward. Install the inner thrust washer
and axle shaft retaining ring.
Figure B–92. Install Axle Seal
3. Reposition the axle assembly with the output end
pointing upward. Protecting the lip of the axle seal
from the snap ring groove and keyway, lubricate and
install the seal with the lip pointing inward towards
the axle housing.
4. Using a piece of tubing (1-1/2” O.D. x 6” long), press
or drive the seal into the counterbore.
SPACER
To Next Page
Loading...
Need help?
General
