7 - 35
7 Transmission Repair
7B Eaton 750 / 751
Figure B–93. Install Retaining Ring
5. Install the sealed ball bearing over the axle shaft, into
the counterbore. Using a pair of No. 5 or 7 internal
snap ring pliers, install the ball bearing retaining ring
in the axle housing.
Figure B–94. Install Thrust Washer On Axle Shaft
6. Reposition the axle housing assembly and install the
large thrust washer on the axle shaft. (Not used on
date code G01J or higher.)
Figure B–95. Install Axle Housing On Transaxle
7. Install the B axle assembly, aligning and engaging
the axle shaft with the secondary carrier assembly.
NOTE: To aid in installation, the axle housings are
marked with the letters A and B. Each side of the hous-
ing assembly is also marked with an A or B. Make sure
the axle housings are correctly assembled with the corre-
sponding letters on the housing assembly.
8. After installing the axle housing, install the capscrews
in the housing and torque them to 125 inch pounds.
NOTE: Repeat the same assembly steps for the other
axle.
To Next Page
Loading...
Need help?
General
