Singer Quantum Stylist
TM
9960 7
3. Needle threader height
Check.
1. Insert a new # 70 needle.
2. Set the machine to straight stitching (center needle position).
3. Bring the needlebar to its highest turning position.
4. Go down with the threader hook into the needle eye, the threader hook shall go smoothly into the
needle eye.
Adjustment of threader hook highways
1. Insert a new # 70 needle.
2. Remove the face cover.
3. Turning the hand wheel by hand to so the needle bar comes to its highest position.
4. Loosen screw (A) of the threader stopper.
5. Go down with the threader hook into the needle eye.
6. Move the threader holder so that the threader hook is on the upper side of the needle eye.
see Fig 1.
7. Tighten the screw (A) . Make sure to attaching the threader stopper onto stopper pin (D).
NOTE! If the direction of threader stopper isn’t correct, the machine will make and/or threader will not
work smoothly.
Adjustment of threader hook sideways
1. If the sideways position of the hook isn’t correct, adjust the hook position with a small screw driver.
2. Recheck that the needle threader works correctly
.
#90 #80
#70
Fig 1
A
To Next Page
Loading...
Need help?
General
