Smartgen APC715 User Manual

APC715 Pump Unit Controller
APC715 Pump Unit Controller ISSUE 2013-08-28 Version 1.0 Page 38 of 62
28
Reserved
29
On-load Output
Control generator to take load or off
load.
30
Reserved
31
Reserved
32
Reserved
33
Crank Relay
Action when genset is starting and
disconnect when crank successful.
34
Fuel Relay
Action when genset is starting and
disconnect when stop is completed.
35
Idle Control
Used for engine which has idles. Close
before starting and open in warming up
delay; Close during stopping idle
process and open when stop is
completed.
36
Raise Speed
Action in warming up delay and be
controlled by GOV in normal running
process.
37
Drop Speed
Action between the period from “stop
idle” to “failed to stop” and be controlled
by GOV in normal running process.
38
ETS Control
Used for engines with ETS
electromagnet. Close when stop idle is
over and open when pre-set “ETS
delay” is over.
39
Pulse Drop speed
Active 0.1s when controller enter into
stop idle, used for control part of ECU
dropping to idle speed (temporary
reserved).
40
ECU Stop
Suitable for engines which fitted with
ECU; used for control ECU stop.
41
ECU Power Supply
Suitable for engines which fitted with
ECU; used for control ECU power
supply.
42
Pulse raise speed
Active 0.1s when controller enter into
warming up delay; used for control part
of ECU raising to normal speed
(temporary reserved).
43
Crank Success
Close when detects a successful start
signal.
44
Reserved
45
Reserved
46
Reserved
47
Start Battery Cycle
During cranking process, start battery

Smartgen APC715 Specifications

General

Brand	Smartgen
Model	APC715
Category	Control Unit
Language	English