A
CCESS
C
ONTROL
L
ISTS
3-85
Binding a Port to an Access Control List
After configuring Access Control Lists (ACL), you should bind them to
the ports that need to filter traffic. You can assign one IP access list to any
port, but you can only assign one MAC access list to all the ports on the
switch.
Command Usage
• You must configure a mask for an ACL rule before you can bind it to
a port.
• This switch only supports ACLs for ingress filtering. You can only
bind one IP ACL to any port, and one MAC ACL globally, for ingress
filtering.
Command Attributes
• Port – Fixed port or SFP module. (Range: 1-26/52)
• IP – Specifies the IP Access List to enable for a port.
• MAC – Specifies the MAC Access List to enable globally.
• IN – ACL for ingress packets.
• ACL Name – Name of the ACL.
To Next Page
Loading...
Need help?
General
