I
NTERFACE
C
OMMANDS
4-155
show interfaces switchport
This command displays the administrative and operational status of the
specified interfaces.
Syntax
show interfaces switchport [interface]
interface
• ethernet unit/port
- unit - Stack unit. (This is unit 1)
- port - Port number. (Range: 1-26/52)
• port-channel channel-id (Range: 1-4)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 24.
Console#show interfaces switchport ethernet 1/24
Broadcast threshold: Enabled, 600 octets/second
LACP status: Enabled
Ingress rate limit: disable, Level: 30
Egress rate limit: disable, Level: 30
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
GVRP status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Private-VLAN mode: NONE
Private-VLAN host-association: NONE
Private-VLAN mapping: NONE
Console#
To Next Page
Loading...
Need help?
General
