A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-125
Example
Related Commands
permit, deny 4-120
ip access-group (4-125)
ip access-group
This command binds a port to an IP ACL. Use the no form to remove the
port.
Syntax
[no] ip access-group acl_name in
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• in – Indicates that this list applies to ingress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different
ACL, the switch will replace the old binding with the new one.
• You must configure a mask for an ACL rule before you can bind it to
a port.
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.16.0 255.255.240.0
Console#
To Next Page
Need help?
General
