SMC Networks 6726AL2 User Manual

L INK A GGREGATION C OMMANDS
4-165
channel-group
This command adds a port to a trunk. Use the no form to remove a port
from a trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-4)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When configuring static trunks, the switches must comply with the
Cisco EtherChannel standard.
•Use no channel-group to remove a port group from a trunk.
•Use no interfaces port-channel to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 11:
lacp
This command enables 802.3ad Link Aggregation Control Protocol
(LACP) for the current interface. Use the no form to disable it.
Syntax
[no] lacp
Default Setting
Disabled
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#

SMC Networks 6726AL2 Specifications

General

Brand	SMC Networks
Model	6726AL2
Category	Network Router
Language	English