C
OMMAND
L
INE
I
NTERFACE
4-166
Command Mode
Interface Configuration (Ethernet)
Command Usage
• The ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.
• A trunk formed with another switch using LACP will automatically be
assigned the next available port-channel ID.
• If the target switch has also enabled LACP on the connected ports, the
trunk will be activated automatically.
• If more than eight ports attached to the same target switch have
LACP enabled, the additional ports will be placed in standby mode,
and will only be enabled if one of the active links fails.
To Next Page
Loading...
Need help?
General
