SNMP C
OMMANDS
4-139
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact (4-138)
snmp-server host
This command specifies the recipient of a Simple Network Management
Protocol notification operation. Use the no form to remove the specified
host.
Syntax
snmp-server host host-addr community-string [version {1 | 2c}]
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you
define this string using the snmp-server community command
prior to using the snmp-server host command. (Maximum length:
32 characters)
• version - Specifies whether to send notifications as SNMP v1 or
v2c traps. (Range: 1, 2c; Default: 1)
Default Setting
Host Address: None
SNMP Version: 1
Command Mode
Global Configuration
Console(config)#snmp-server location Room 23
Console(config)#
To Next Page
Loading...
Need help?
General
