VLAN C
ONFIGURATION
3-155
• Mode – Indicates VLAN membership mode for an interface.
(Default: Hybrid)
- 1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port transmits
tagged frames that identify the source VLAN. Note that frames
belonging to the port’s default VLAN (i.e., associated with the
PVID) are also transmitted as tagged frames.
- Hybrid – Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
• Trunk Member – Indicates if a port is a member of a trunk. To add a
trunk to the selected VLAN, use the last table on the VLAN Static
Table page.
Web – Click VLAN, 802.1Q VLAN, Port Configuration or VLAN Trunk
Configuration. Fill in the required settings for each interface, click Apply.
Figure 3-66 VLAN Port Configuration
To Next Page
Loading...
Need help?
General
