SMC Networks mentor 12 User Manual

MENTOR 12 USER’S MANUAL SECTION 3: ADVANCED CONTROL – Page 61
• If you have selected FREQUENCY, a tag will
appear which indicates that “the ramp will be
applied to all the channels in Freq. 1” and the
indicators of all the sources that are in Frequency
1. These icons are only indicators and you cannot
select them as they are already selected.
• When you have made your selection, press OK to
confirm and return to the configuration screen, or
CANCEL to return to the configuration screen
without making any selection.
• On the configuration screen, following the “Signal
1” key there must be a tag that indicates the
parameter (Amplitude or Phase), the type of signal
selected (Voltage or Current) and the output
sources that the ramp will carry out (C1, C2, etc).
• If you have selected FREQUENCY, the tag
indicates Frequency and that it is applied to all the
sources in FREQ. 1
• Enter the desired values to execute the ramp on
the data input windows of the graphic. You must
enter values for the magnitude (white-colored
window and in the relative unit) and values for the
durations (blue-colored window and in
milliseconds).
• Enter this value using the rotary knob in the window that defines the initial
value of the magnitude (on the green line). The ramp will begin to apply the
increases on this value.

SMC Networks mentor 12 Specifications

General

Brand	SMC Networks
Model	mentor 12
Category	Test Equipment
Language	English