28
— Playback – Basics —
Playing back a tape
You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can also control playback
using the Remote Commander supplied with your camcorder.
(1) Install the power source and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button. The
video control buttons light up.
(3) Slide OPEN in the direction of the B mark to open the LCD panel.
(4) Press m to rewind the tape.
(5) Press N to start playback.
(6) To adjust the volume, press either of the VOLUME +/– buttons .
To stop playback
Press x.
4
2
6
1
3
VOLUME
5
POWER
OFF
(CHG)
CAMERA
MEMORY
VCR
PLAYREW
To Next Page
Loading...
Need help?
General