94
Switching the time value
Press TC/U-BIT. Each time you press TC/U-BIT, the time value changes between the
time code and user bits.
TC: Displays the time code. This is indicated as “00:00:00:00”.
U-BIT: Displays user bits. This is indicated as “00 00 00 00”.
Note
The time code and user bits cannot be displayed properly if the tape does not have time
code and/or user bits recordings or if the time code was recorded using a non-
compatible method.
Setting time values
TC/U-BIT
Time code/user bits
To Next Page
Loading...
Need help?
General