us
54
• Access to the "Memory Stick PRO Duo" media
was restricted
on
another device.
i
(HDR-XR200/XR200V)
• There
is
something wrong with the flash.
• The amount
of
light
is
not sufficient.
Use
the
flash. (HDR-XR200/XR200V)
• The camcorder
is
unsteady. Hold the camcorder
steady with both hands. However, note that
the camera-shake warning indicator does not
disappear.
• The
drop
sensor function
is
activated.
You
may
not
be able to record
nor
play back
images.
• The recording media
is
full. Delete unnecessary
images (p. 42).
• Photos cannot be recorded during processing.
Wait for a while, then record.
Precautions
On use and care
• Do not use or store the camcorder and
accessories in the following locations:
- Anywhere extremely hot, cold or humid.
Never leave them exposed to temperatures
above
60°C
(140
OF),
such as under direct
sunlight, near heaters or in a car parked
in
the sun. They may malfunction
or
become
deformed.
- Near strong magnetic fields or mechanical
vibration. The camcorder may malfunction.
- Near strong radio waves or radiation. The
camcorder may not be able to record properly.
- Near AM receivers and video equipment.
Noise may occur.
-
On
a sandy beach or anywhere dusty. If
sand or dust gets in your camcorder,
it
may
malfunction. Sometimes this malfunction
cannot be repaired.
- Near windows or outdoors, where the LCD
screen or the lens may be exposed to direct
sunlight. This damages the inside
of
the LCD
screen.
• Operate your camcorder on
DC
6.8
V!7.2 V
(battery pack) or DC 8.4 V (AC Adaptor).
• For DC or
AC
operation, use the accessories
recommended in these operating instructions.
• Do not let your camcorder get wet, for example,
from rain
or
sea water. Ifyour camcorder
gets wet, it may malfunction. Sometimes this
malfunction cannot be repaired.
• Ifany solid object or liquid gets inside the
casing, unplug your camcorder and have it
checked by a Sony dealer before operating
it
any further.
• Avoid rough handling, disassembling,
mOdifying, physical shock, or impact such
as hammering, dropping or stepping on the
product.
Be
particularly careful
of
the lens.
• Keep the camcorder turning offwhen you are
not using your camcorder.
• Do not wrap your camcorder with a towel, for
example, and operate
it.
Doing so might cause
heat to build up inside.
• When disconnecting the power cord (mains
lead), pull it
by
the plug and not the cord (lead).
To Next Page
Loading...
Need help?
General
