us
8
The numbers in ( ) are the supplied
quantity.
o AC Adaptor (1)
o Power cord (Mains lead) (1)
o Component A/V cable (1)
[AI
o A/V connecting cable (1)
~
o
USB
cable (1)
[Q
o Wireless Remote
Commander
(1)
(only for HDR-XR200/XR200V)
• A button-type lithium battery
is
already
installed. Remove the insulation sheet before
using the Wireless Remote Commander.
o Rechargeable battery pack NP-FH60 (1)
o CD-ROM "Handycam Application
Software" (1)
- "PMB" (software, including "PMB Guide")
- "Handycam Handbook"
(PDf)
o "Operating Guide" (This manual) (1)
[AI
~
[Q
~
-€e¥':O;:
•
See
page 44 for the "Memory Stick" media you
can use with this camcorder.
Using
the camcorder
• The camcorder
is
not dustproofed, dripproofed
or waterproofed.
See
"Precautions" (p. 54).
• Do not do any
of
the following when the
ICI
(Movie)/O
(Photo) mode lamps (p.
15)
or the
ACCESS
lamps
(p.
13),
the
access
lamp
(p.
44)
are lit or flashing. Otherwise, the recording
media may be damaged, recorded images may
be lost or other malfunctions could occur.
- ejecting the "Memory Stick PRO Duo" media
- removing the battery pack or
AC
Adaptor
from the camcorder
• Do not apply shock or vibration to the
camcorder. The camcorder may not be able to
record or play movies and photos.
• Do not use the camcorder in very loud areas.
The camcorder may not be able to record or
play movies and photos.
• When connecting the camcorder to another
device with communication cables, be sure to
insert the connector plug in the correct
way.
Pushing the plug forcibly into the terminal
will damage the terminal and may result in a
malfunction
of
the camcorder.
• Do not close the LCD screen when the
camcorder
is
connected to another device with
the
USB
cable. Your recorded images may be
lost.
• Even ifthe camcorder
is
turned off, the GPS
function
is
working
as
long as the GPS switch
is
set to ON. Make sure that the GPS switch
is
set to OFF during take offand landing
of
an
airplane (HDR-XR200V).
•
To
protect the internal hard disk from shock
by dropping, the camcorder has drop sensor
function. When a drop occurs, or under a non-
gravity condition, the block noise made when
this function
is
activated by the camcorder may
also be recorded.
If
the drop sensor catches a
drop repeatedly, recording/playback may be
stopped.
• When the temperature
of
the camcorder
becomes extremely high or extremely
low,
you
may not be able to record or play back on the
camcorder, due to the protection features
of
the
camcorder being activated in such situations. In
this case, a message appears on the LCD screen
(p. 53).
• Do not turn on the camcorder in a low-pressure
area, where the altitude
is
more than 5,000
meters (16,000 feet). Doing so may damage the
hard disk drive
of
the camcorder.
•
If
you
repeat recording/deleting images for
a long time, fragmentation
of
data occurs on
the recording media. Images cannot be saved
or recorded. In such a case, save your images
To Next Page
Loading...
Need help?
General
