129
US
Additional Information
• Make sure that the command modes of the
receiver and the remote control are the
same. If the command mode of the
receiver and the remote control are
different, you cannot operate the receiver
with the remote control (page 87).
• Make sure you select the correct input on
the remote control.
If the trouble is other than one of the cases
described above and the trouble is not solved
even if you wait for a while, perform either of
the operations below.
• Press ?/1 on the remote control to turn the
receiver off and then on again.
• Hold down ?/1 on the receiver until the
lamp above the button flashes in green to
reboot the receiver.
The Universal Remote Control function
does not work.
• Make sure the connections required are
made.
If the trouble is other than one of the cases
described above and the trouble is not
solved even if you wait for a while,
perform either of the operations below.
• Press ?/1 on the remote control to turn the
receiver off and then on again.
• Hold down ?/1 on the receiver until the
lamp above the button flashes in green to
reboot the receiver.
• If the remote sensor of the receiver and
that of another Sony product face the same
direction, interference may occur. In this
case, set the remote sensors so that they
face different directions or use an IR shield
on the other Sony product to shield the IR
from interference from the receiver IR
remote.
• Make sure the receiver is connected to the
Internet.
• Press ROOM OFF on the remote control to
turn off the receiver and the AV
equipment.
The lighting device cannot be
identified.
• Try pressing the button on the top of the
lighting device 4 times. Then repeat this
procedure more than once.
• If the LED continues blinking weakly,
press and hold the button on the lighting
device for 5 seconds then tap four times on
the button on the wizard.
• To reset the lighting device, press the
button on the top of the lighting device 13
times. the LED will turn to red and then
back to green or emit an orange-yellow
strobe.
The lighting device cannot be
operated.
• The device may be updating its software.
Wait for about half an hour until the update
is completed.
• It may be off-line. Wait for half an hour
until the device returns online.
• Reset the lighting device and delete the
identified device on the receiver. Reboot
the receiver and then set up the Lighting
Control function again. Also perform the
procedures necessary to reset the lighting
device described above.
The Lighting Control function doesn’t
work.
• The Lighting Control Adapter may have
been unplugged while the power was on
and the system data may be corrupted.
Reset the lighting device and delete the
identified devices on the receiver. Then
reboot the receiver and set up the Lighting
Control function again.
• Hold down ?/1 on the receiver until the
lamp above ?/1 flashes in green to reboot
the receiver.
Universal Remote Control
Lighting Control
To Next Page
Loading...
Need help?
General
Weight and Dimensions
