116
US
Buttons such as 2 +/–, N, X, x,
., >, SHUFFLE and REPEAT do
not work.
• Make sure that the settings that allow
iTunes to accept control from this
receiver are active.
• The receiver is not selected as the
remote speaker on the iOS device.
Select the receiver as the network
speaker.
You cannot connect the receiver to a
service.
• Make sure that the wireless LAN
router/access point is turned on.
• Check the network status. See
“Information” (page 95), then select
“Physical Connection” in step 2. If
“Connection Fail” appears, set up the
network connection again (page 57).
• When the system is connected to the
wireless network, move the receiver
and the wireless LAN router/access
point closer to each other.
• If your contract with your Internet
provider limits Internet connection to
one device at a time, this device will
not be able to access the Internet when
another device is already connected.
Consult your carrier or service
provider.
The sound skips.
• The bandwidth of your wireless LAN
may be too low. Move the receiver and
the wireless LAN router/access point
closer to each other, without any
obstacles between.
Pairing cannot be done.
•Move the Bluetooth device closer to
the receiver.
• Pairing may not be possible if other
Bluetooth devices are present around
the receiver. In this case, turn off the
other Bluetooth devices.
• Enter the same passkey that was
entered at the Bluetooth device
correctly (page 76).
Cannot make the Bluetooth
connection.
•The Bluetooth device you attempted to
connect does not support the A2DP
profile, and cannot be connected with
the receiver.
• Press BLUETOOTH on the receiver to
connect to the last connected Bluetooth
device.
• Turn on the Bluetooth function of the
Bluetooth device.
• Establish a connection from the
Bluetooth device.
• The pairing registration information
has been erased. Perform the pairing
operation again (page 76).
• While connected to a Bluetooth device,
this receiver cannot be detected and a
connection cannot be established from
another Bluetooth device.
• Erase the pairing registration
information of a Bluetooth device
(page 76) and perform the pairing
operation again.
The sound skips or fluctuates, or the
connection is lost.
• The receiver and the Bluetooth device
are too far apart.
• If there are obstacles between the
receiver and your Bluetooth device,
remove or avoid the obstacles.
SEN
Bluetooth device
To Next Page
Loading...
Need help?
General
Weight and Dimensions
