92
US
• When the front speakers are set to “Small”, the
center, surround, and surround back/front high
speakers are also automatically set to “Small”.
• If you do not use the subwoofer, the front
speakers are automatically set to “Large”.
x Crossover Freq. (Speaker
crossover frequency)
Lets you set the bass crossover frequency
of speakers that the speaker size has been
set to “Small” in the Speaker Settings
menu. Measured speaker crossover
frequency is set for each speaker after the
Auto Calibration.
1 Select the parameter under the
speaker on the screen for which you
want to adjust the crossover
frequency, then press .
2 Adjust the value, then press .
x Test Tone
Lets you select the test tone type on the
“Test Tone” screen.
• To adjust the level of all speakers at the same
time, press
2 +/–. You can also use MASTER
VOLUME on the receiver.
• The adjusted value is shown on the TV screen
during adjustment.
To output test tone from each
speaker
You can output test tone from the speakers
in sequence.
1 Select “Test Tone”, then press .
2 Select the type of test tone or
speaker you want, then press .
• Off: The test tone is output from each
speaker manually.
• Auto: The test tone is output from each
speaker in sequence.
• Fix FL, Fix FR, Fix CNT, Fix SL, Fix
SR, Fix SB*, Fix SBL, Fix SBR, Fix
LH, Fix RH, Fix SW: You can select
which speakers will output the test
tone.
3 Adjust the speaker level for manual
test tone, then press .
* “Fix SB” appears when only one surround back
speaker is connected.
x Distance Unit
Lets you select the unit of measurement for
setting distances.
• feet: The distance is displayed in feet.
• meter: The distance is displayed in
meters.
Audio Settings menu
You can adjust settings for the audio to suit
your preference.
x D.L.L. (Digital Legato Linear)
The D.L.L. function is Sony proprietary
technology that allows low quality digital
audio signals and analog audio signals to be
played back with high quality sound.
• Auto 1: This function is available for
lossy compression audio formats and
analog audio signals.
• Auto 2: This function is available for
Linear PCM signals, as well as lossy
compression audio formats and analog
audio signals.
•Off
• This function may not work, depending on the
content via a USB device, or a home network.
• This function works when “A.F.D. Auto”,
“Multi Stereo”, “2ch Stereo”, or “Headphone
(2ch)” is selected. However, this function does
not work in the following cases.
– “FM TUNER” or “AM TUNER” input is
selected.
– Linear PCM signals with a sampling
frequency of other than 44.1 kHz are being
received.
– Dolby Digital Plus, Dolby Digital EX, Dolby
TrueHD, DTS 96/24, DTS-HD Master Audio,
or DTS-HD High Resolution Audio signals
are being received.
– During network function, signals with a
sampling frequency of other than 44.1 kHz is
being received.
Tips
Notes
To Next Page
Loading...
Need help?
General
Weight and Dimensions
