Legacy U.S.A. (E)
3
Instruments and controls
3-11
– CONTINUED –
checked by an authorized SUBARU dealer immediately.
J ABS warning light (for vehicles with ABS)
The ABS warning light comes on when the ignition switch is turned to the
“ON” position and goes out after about two seconds.
This is an indication that the ABS system is working properly.
If the warning light behaves as follows, ABS system may not work prop-
erly.
D The warning light does not come on when the ignition switch is turned
to the “ON” position.
D The warning light comes on when the ignition switch is turned to the
“ON” position, but it does not go out even when the vehicle speed
exceeds approximately 8 mph (12 km/h).
D The warning light comes on during driving.
Contact your nearest SUBARU dealer for service immediately.
NOTE
If the warning light behavior is as shown below, the ABS system may be
considered normal.
D The warning light comes on when the ignition switch is turned to the
“ON” position but goes out immediately, remaining off.
D The warning light remains on after the engine has been started, but it
goes out when the vehicle speed reaches about 8 mph (12 km/h).
D The warning light comes on during driving, but it goes out immedi-
ately and remains off.
When the ABS warning light is on, the ABS function shuts down; how-
ever, the conventional brake system continues to operate normally.
Refer to the ABS (Anti-Lock Brake System) Section in chapter 7.
J AT OIL TEMPerature warning light (for AT vehicles)
If this light comes on when the engine is running, it may indicate that the
automatic transmission fluid temperature is too hot.
If the light comes on while driving, it is unnecessary to stop the vehicle,
but avoid driving up steep grades or in stop and go traffic.
(U.S.)
(Canada)
ABS
To Next Page
Loading...
Need help?
General
